BOM imports as compressed...????

[3dr]

I have a standard BOM that I always bring in using "Import" - "Part". It works fine but on this particular job it's only displaying 2 of 84 parts. The others are compressed into a single line item displaying (82 pcs) I've tried editing "Leaves" but I don't fully understans them and have had no luck.

Anyone out there have an idea???

Dave

 

[hudson888]

Is this a part list on a drawing?

If so the problem will most likely be remedied by editing the parts list using the "Edit Levels" command.

Best Regards

Hudson

www.jamb.com.au

Nil Desperandum illegitimi non carborundum

 

[3dr]

Yes it's a parts list. I tried editing levels but it just didn't work.

I wound up making a new one from scratch to work around it.

Dave