BOM Table in Drawing??

[Speedy]

Folks,

There is probably a very simple answer to this but here goes;

How does one create a BOM (Bill of materials) as a Table in an assembly drawing?

Surely there is a standard BOM Table within pro-e that I can use. I went throughh the help menu but??? I did a search on this site and found something about "repeat parameters" in standard tables.

Appreciate any help.

Speedy

 

[ttx]

Speedy,
This is a good place to start.

http://www.proecentral.com/portal/articles/articlesDetail.asp?id=22

Unfortunately with Pro/E, you have to build your BOM tables from scratch. Once you have done it once and saved it in a format, it will always be there when you want it and from that point, you can customize it with relations and filters for your specific needs.

Cheers,

JW