Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

BOMs of Family Tabled Assemblies

Thread starter mikehmi
Start date Nov 6, 2002

Status: Not open for further replies.

Nov 6, 2002

mikehmi

Mechanical

I have a family tabled assembly with multiple instances. I would like to create a BOM that shows the components in rows and the instance in columns with the quantities inside. I have been able to show a 2D repeat region that shows everything but the quantities. All I can get inside is the Y or N denoting if that particular instance has that particular component. Is there anyway to accomplish this without having to make a separate BOM table for each instance?

Thanks for the help.