Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bond slip modeling in ANSYS using combin39

Status
Not open for further replies.
myMatlab

myMatlab

Structural
Oct 15, 2012
3
Dear friends,

I want to model an RC shear wall using ANSYS. Solid65 and Link8 elements are employed to model concrete and steel bars, respectively. For bond slip between concrete and reinforcement, I want to use combin39, but I don't know how to create this element between Solid65 and Link8 elements that are matched in nodes (in fact creating a zero length combin39 element).

Would you please give me your valuable ideas?

Thanks,
myMatlab
 
Status
Not open for further replies.

Similar threads

D
Random vibration in ANSYS APDL using results from Linear Perturbation
Replies
1
Views
2K
hacksaw
hacksaw
Kamyar_K
  • Locked
  • Question
Slip in the rigid railroad track - ABAQUS model
Replies
3
Views
226
Kamyar_K
Kamyar_K
Kamyar_K
  • Locked
  • Question
Changing the slip interface by loading rate
Replies
0
Views
134
Kamyar_K
Kamyar_K
raslraslov
  • Locked
  • Question
Setting up units in nCode when importing d3plot (ANSYS)
Replies
0
Views
300
raslraslov
raslraslov
oharag11
  • Locked
  • Question
Modeling/simulating thermal vias - PCB/Electonic thermal analysis?
Replies
0
Views
431
oharag11
oharag11

Part and Inventory Search

Sponsor

Back
Top Bottom