Boundary conditions in two different coordinate systems

[RGX124]

Hi,

I have a problem applying displacement boundary conditions in two differents planes with a common edge.
The displacement normal to the planes have to be set two zero. I have created a local coordinate system. However, this causes a problem.
When I create the input file, I obtain the following message.
"The following pairs of attributes are applied to overlapping/intersecting/adjoining regions in differing coordinate systems."

How is it possible to sort out this issue? (without equations)

Thanks

R

 

[corus]

If you've defined the faces as sets then remove the common edge from one of the sets by using the ctrl button when selecting.

corus

 

[RGX124]

Thanks Corus.
It worked