Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Boundary conditions

Status
Not open for further replies.
moliPHD

moliPHD

Mechanical
Jun 4, 2014
15
Hi friends,
In bending 3 points (3D), what are the boundary conditions concerning the supports alongside (UX, UY, UZ, ROTX, ROTY, ROTZ) and force applied in the middle.
Regards.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
The same as the boundary conditions you would get from the free body diagram you would draw if you were finding a closed-form solution.

Rick Fischer
Principal Engineer
Argonne National Laboratory
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

shiraz883
  • Locked
  • Question
Stresses increase on adding thermal boundary conditions/ thermal load
Replies
1
Views
99
SWComposites
SWComposites
andradesilva
  • Locked
  • Question
how to apply symmetry boundary conditions in ANSYS workbench 2023 R1
Replies
0
Views
115
andradesilva
andradesilva
vickyiamlucky
  • Locked
  • Question
Ansys Symmetry model to full model cut boundary dispacemnt or force bc
Replies
0
Views
180
vickyiamlucky
vickyiamlucky
cbk14
  • Locked
  • Question
No boundary conditions listed in PSD G Accel load in Random Vib (Ansys Mechanical)
Replies
1
Views
107
cbk14
cbk14
Pekkeri
  • Locked
  • Question
Simple trailer stat. struct. analysis boundary conditions
Replies
0
Views
27
Pekkeri
Pekkeri

Part and Inventory Search

Sponsor

Back
Top Bottom