break-out section view of an assembly

[dtharrett]

I forget where I got these instructions from but see if they help.

 

[jerry1423]

I think it will work if you do two seperate "break-outs" in that one view. One break-out would be on the side face of the battery case, and the other on the end face.

 

[Walterke]

@dtharrett, that's from the XN help. I know how to make a brake-out section, I just can't seem to figure out how to do it properly in an angled view, as in my picture.

@Jerry, I don't really understand what you're saying. Care to add some more explanation?

NX 7.5
Teamcenter 8