Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BREAK OUT SECTION 1
- Thread starter EngMfg1
- Start date
-
1
- #2
BelgiumEurope
Mechanical
· Use rigt mouse click at iso view
· Click Expand
· Go to WCS -> Orient and take Csys of objects (box inferred)
· Click af model so that xy axis will be in correct position , for cutting 3d iso view
· Make with curve a rectangle in XY face ( this will be the cut out area)
· Click Right mous expand off (back in drawing selection)
· Take break out function at toolbar
· Select view
· Indicate base point (on a cylinder , click face make sure that it will the right vector direction “indicate extrusion vector)
· Then select the four sides of the rectangle curve make sure you go each four
· The choose apply
· And Yes a great victory it is ( It is cut out , I hope
)
· Click Expand
· Go to WCS -> Orient and take Csys of objects (box inferred)
· Click af model so that xy axis will be in correct position , for cutting 3d iso view
· Make with curve a rectangle in XY face ( this will be the cut out area)
· Click Right mous expand off (back in drawing selection)
· Take break out function at toolbar
· Select view
· Indicate base point (on a cylinder , click face make sure that it will the right vector direction “indicate extrusion vector)
· Then select the four sides of the rectangle curve make sure you go each four
· The choose apply
· And Yes a great victory it is ( It is cut out , I hope
) - Status
