Broken view of section view

[cubalibre000]

Hi I'm not able to add a Broken view of section view. I thought to use bounded tool, but I need to broken a shaft that is long and I need two interruption.

Thank you...

Using NX 8 and TC9.1

 

[jerry1423]

Is it a simple, straight, section view ?

 

[cubalibre000]

Jerry,
it's a revolved section.

Thank you...

Using NX 8 and TC9.1

 

[jerry1423]

I guess you can't make a broken view from a section view.
Maybe that will change in the future.

 

[JohnRBaker]

You can however 'section' a Broken View.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[kapmnit123]

Hi,
As of now the only workaround i can think of of is...Create a PMI revolved section and bring this as a base view and then it can be broken up as per requirement.
Best REgards
Kapil

 

[cubalibre000]

Hi Kapil, I don't have PMI license.
I will add an ER.

Thank you...

Using NX 8 and TC9.1