Broken view problems

[gatnact]

I was wondering if I was the only one who had this problem. When I put a broken view on a part every time I rebuild it seams to suppress the broken part and make the part full size. Now this is an easy fix, all I have to do is hit the rebuild button again. But when I have more than one sheet I have to make sure all the sheets have been rebuilt to satisfaction. I am currently using sw08 x64 and I had this problem in sw07 x64 as well as sw07. Any help would be great. Thank you.

 

[SBaugh]

If you hit Ctrl-Q does the view disappear again? If so, then rebuilding is not really a fix. I would send this to your VAR with a SW RX of the issue.

Regards,

Scott Baugh, CSWP

http://www.scottjbaugh.com

"If it's not broke, Don't fix it!"

faq731-376

 

[gatnact]

I have sent it and they never got back to me when I had 2007, but I will send it again, and again, and again until sombody helps