Feb 25, 2013 #1 cadmate Mechanical May 5, 2005 84 0 0 GB Hello there, does anyone know how to create an 'S' shaped broken view of a shaft rather than the rectangular or structural? Thanks in advance
Hello there, does anyone know how to create an 'S' shaped broken view of a shaft rather than the rectangular or structural? Thanks in advance
Feb 25, 2013 #2 rollupswx Mechanical Dec 31, 2007 918 0 0 US You will have to sketch it like the old days on the drawing board or in AutoCAD. Upvote 0 Downvote
Feb 28, 2013 Thread starter #3 cadmate Mechanical May 5, 2005 84 0 0 GB Hi rollupswx, yea can do that, but will lose the auto dim i.e will have to manually dimention which can be dangerous if some one changes the length of the shaft. Needs adding to the Inventor wish list Upvote 0 Downvote
Hi rollupswx, yea can do that, but will lose the auto dim i.e will have to manually dimention which can be dangerous if some one changes the length of the shaft. Needs adding to the Inventor wish list
Feb 28, 2013 #4 rollupswx Mechanical Dec 31, 2007 918 0 0 US Share your idea. http://forums.autodesk.com/t5/Inventor-IdeaStation/idb-p/v1232 Upvote 0 Downvote
Feb 28, 2013 Thread starter #5 cadmate Mechanical May 5, 2005 84 0 0 GB Rollupswx, done that thanks, do these ideas just get locked in a dark room and get forgotten about though? Upvote 0 Downvote
Rollupswx, done that thanks, do these ideas just get locked in a dark room and get forgotten about though?