beachcomber
Mechanical
- Jan 19, 2005
- 1,488
I have a view on a drawing that has several breaks along it.
My question is can I re-define the position of these breaks or can I add another break?
I know how to remove all breaks and remove a single break but I have added a feature that (by sod's law) falls in one of the breaks. I have the break to get the detail to appear and now need to add another break to get the view to fit the drawing sheet again.
The Break View icon is greyed out and not available for this view.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
My question is can I re-define the position of these breaks or can I add another break?
I know how to remove all breaks and remove a single break but I have added a feature that (by sod's law) falls in one of the breaks. I have the break to get the detail to appear and now need to add another break to get the view to fit the drawing sheet again.
The Break View icon is greyed out and not available for this view.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?