Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Buckling calculation hydraulic cylinder

Thread starter Patzun
Start date Jan 12, 2009

Status: Not open for further replies.

Jan 12, 2009

Patzun

Industrial

I would like to know as is the calculation of buckling of a shank. I have a doubt, I do not know if I should make a single piece and apply a compressive force on the rod or if I have to do two pieces, and apply internal pressure. Thank you very much for everything.