Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bugwith contour levels? (version 11.0.1)

Status
Not open for further replies.

Worldtraveller

Aerospace
Sep 25, 2013
82
I have a model that's a simple 2D plate. I am trying to adjust the contour levels with more than the default 16.

When I change it display more levels, (say, from 16 to 24) the scale from the max to zero stays the same (8 levels) and it increases the number of levels between zero and the min stress.

Is this a known bug, or am I missing a setting/switch somewhere that allows it to scale more appropriately. The plate I am modelling has enough symmetry, that I want zero to be at the center of the scale.
 
Replies continue below

Recommended for you

What version of Femap are you using and what output vector are trying to contour?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor