Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bulk part in simplified rep

Status
Not open for further replies.
SENTRYDAN

SENTRYDAN

Mechanical
Jan 17, 2005
21
0
0
US
I created an assembly with a simplified rep and bulk parts. How do I put the bulk parts into the simplified rep? The BOM in the drawing is set to that simplified rep and won't show the bulk parts.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Not sure, but my guess is you can't.

Bulk parts have no geometry so there is nothing in them that can be put into a simplified rep.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

freerangequark
  • Locked
  • Question
Control of a dimension or parameter in simplified rep?
Replies
1
Views
26
3DDave
3DDave
whatev-nvm
  • Locked
  • Question
OBJ of a simp rep of an assembly gets exported with incorrect coordinate system
Replies
0
Views
24
whatev-nvm
whatev-nvm
freerangequark
  • Locked
  • Question
Error in start part relations
Replies
15
Views
62
freerangequark
freerangequark
freerangequark
  • Locked
  • Question
Model Tree, tracking part identity 1
Replies
2
Views
22
geesaman.d
geesaman.d
Mras
  • Locked
  • Question
Creo part tolerance (point coincidence tolerance)
Replies
1
Views
24
3DDave
3DDave
Back
Top