Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations Danlap on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bushing Contact

Thread starter lLouie
Start date Thursday at 8:51 AM

Thursday at 8:51 AM

lLouie

Student

There is a bushing between the pin and the part. I am loading the part up and down. Therefore, I expect stresses to occur in the hole area of the part, but I am not sure which contact type I should give between the bushing and the part in Ansys. I think that if I give Bonded, it will not reflect the load completely.