Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cable family tables in Wildfire 2.0

Thread starter proveteran
Start date Jul 20, 2004

Status: Not open for further replies.

Jul 20, 2004

proveteran

Mechanical

Can anyone explain how to create family tables of a cable harness to update with assembly instances?

PTC support SPR 614852 states: "The ability to create harness family tables has been implemented in Pro/ENGINEER Wildfire. In this Release, the assembly instances may be used as Ref Models in the harness's family table, and the locations would update accordingly."