Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

cage to slip ring

Status
Not open for further replies.
kunalw

kunalw

Electrical
Apr 21, 2000
22
0
0
IN
how to go for cage to slpring.<br>procedure is required .<br>thanking you for responding
 
Replies continue below

Recommended for you

Sort by date Sort by votes
The Slipring motor has better torque caracteristics than cage motor.So Slip motor can definately replace cage motor.But you will have to intall a manul/Auto 3 or 4 steps starter for Slipring motor rotor. <br><br>Regards <br>Khalid Khan
 
Upvote 0 Downvote
The Slipring motor has better torque caracteristics than cage motor.So Slip motor can definately replace cage motor.But you will have to intall a manul/Auto 3 or 4 steps starter for Slipring motor rotor. <br><br>Regards <br>Khalid Khan
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

itsmetinnie
  • Locked
  • Question
Squirrel Cage motor with space heater and PTC 1
Replies
3
Views
4
che12345
che12345
electricpete
  • Locked
  • Question
Portable antenna-based EMI detection of arcing at wound rotor motor slip rings? 1
Replies
5
Views
11
waross
waross
EL AABD Jamal
  • Locked
  • Question
Slip ring failure of ABB AML 630L6A BAM 2
Replies
16
Views
17
dArsonval
dArsonval
Zhk1983
  • Locked
  • Question
Wave winding slip ring motor
Replies
0
Views
1
Zhk1983
Zhk1983
NickParker
  • Locked
  • Question
Upgrade IP 55 motor to IP 56 2
Replies
10
Views
18
SilverfoxUK
SilverfoxUK
Back
Top