Calculating over-bend for sheet metal (Catia V5R15)

[gcpdesign]

Hi guys, I need to bend some sheet metal. Is there an add-in or other program with which one can calculate the extra bend needed. eg. 90° angle 2mm thk result, would need to be bent at 92° to end up as required.
Any help will do.
Thanks, Gary.

 

[DBezaire]

Gary - I work in molds but did you check out this module from Dassault

http://www.3ds.com/products-solutio...sign/product/SH1/?no_cache=1&cHash=7fe3e7e91e

Regards,
Derek

 

[DBezaire]

Gary, Also check this out

http://www.3ds.com/products-solutio...sign/product/SMD/?no_cache=1&cHash=236b466dbf