Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Calculating peak currents

Status
Not open for further replies.
pace

pace

Electrical
Dec 13, 2001
6
IEC60909 uses an equivalent impedance assuming a frequency of 20Hz for the calculation of the R/X ratio to determine peak currents in a meshed network (cl 4.3.1.2).
Does anyone know why 20Hz is used?
 
Status
Not open for further replies.

Similar threads

E. Kermendy
  • Locked
  • Question
Transference of earth fault currents to PV Plant Earthing System from interconnect substation
Replies
1
Views
78
DBL-E
DBL-E
PaulKraemer
  • Locked
  • Question
Calculating resistance in a 3 phase heater circuit
Replies
12
Views
2K
waross
waross
rand1234
  • Locked
  • Question
Transformer Core Ground to Tank Connection - Adding Resistor To Mitigate Circulating Currents
Replies
1
Views
81
stevenal
stevenal
S_S_IBRAHIM
  • Locked
  • Question
Calculating start/stop time for induction motor 1
Replies
10
Views
387
LionelHutz
LionelHutz
tapankatwala
  • Locked
  • Question
Estimating available capacity based on peak demand
Replies
1
Views
48
PHovnanian
PHovnanian

Part and Inventory Search

Sponsor

Back
Top Bottom