Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cam Followers

Status
Not open for further replies.
pclegg25

pclegg25

Automotive
Aug 27, 2002
14
0
0
GB
I am designing an RHS framework which must lift up and down appr. 300mm. I have looked at various options as means of doing this. The framework is appr. 1400mm Sq. I have source some 40mm o/d cam followers from SKF. I've had no experience with these and could do with some input. Is using RHC as the actual track sufficient, or should I machine something with slight clearance to allow rotation of the followers? I will be using 4 cam follerr, 2 each side pitched @ 800mm.

Many thanks

pclegg25
 
Status
Not open for further replies.

Similar threads

salgul
  • Locked
  • Question
Which CAM software 1
Replies
5
Views
9
MintJulep
MintJulep
MAR_SCI
  • Locked
  • Question
reef camera trap
Replies
16
Views
17
dik
dik
JVD2
  • Locked
  • Question
Cam groove Design
Replies
3
Views
4
gearguru
gearguru
stealthmode123
  • Locked
  • Question
Complete Casting Handbook by John Campbell vs ASM Volume 15 Casting Handbook
Replies
0
Views
2
stealthmode123
stealthmode123
Ron247
  • Locked
  • Question
What is the difference (if any) of a thermal versus infrared camera?
Replies
11
Views
12
Ron
Ron
Back
Top