Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Can a feature be use to populate a bill of materials??

Status
Not open for further replies.

Sojournerman

Industrial
Jun 5, 2014
29
I was thinking about this when I last used SW properly 10+ years ago and as I'm getting back into it I thought I may as well ask the question.
As I'm doing a kitchen up in solidworks I would like to have a couple of custom part features that suit certain hardware (eg blum hinge and hinge mount) and was thinking instead of actually inserting the parts is there a way of have the feature required to be used for said part tell the bill of materials whats required to complete the units.
The feature(S)are required for cnc positioning (obviously) but the hinges and mounts because the way they fit never changes are not really required.
Maybe even have configs of the feature which simply refer to different type s of hinges ( the actual drilling does not change)
Hope this is clearer than mud
and as all ways (russian accent) have a nice day;)
 
Replies continue below

Recommended for you

The closest thing to what you are asking for that I know of is the smart component functionality. You place a component in the assembly and it generates features. In a way it is the reverse of what you are asking for, but it might get you both features and accurate BoM in less time.

Eric
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor