Can i place section view of a Broken view

[koutilya]

Hi All,

I am using NX6.0.2.8. I have a broken view in my drawing sheet. But i am not able to create a section view from that broken view. Any suggestions?

 

[JohnRBaker]

That has not been supported prior to NX 8.0.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.