I need an ammonia pump (vertical can type) with specification : capacity 30 m3/h, total head 13.5 kg/cm2and NPSH A. = 0.4 m. Is it possible to get a pump with dia. Of barrel < 700 mm and distance between center line of suction nozzle and bottom of barrel < 1700 mm ?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
CAN TYPE PUMP
- Thread starter purnawan
- Start date
the best solution is to forward all process conditions, fluid properties, and any space limitations to vendors and have the vendors determine whether or not your requirements can be met. actually, you the engineer should determine whether or not the proposed pump will meet space requirements.
the case may be that you will need to make design changes.
-pmover
the case may be that you will need to make design changes.
-pmover
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question