Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cannot change tolerance height in wildfire 5.0 1

Status
Not open for further replies.

jake98

Mechanical
Mar 7, 2008
2
Hello,
I've been trying to change the tolerance height and width to
dimension ratios in the drawing options, but even though it
takes my changes and supposedly "applies" them, there is still
no change to the tolerance height, it still displays the same
size as the associated dimension. I'm wondering if anyone else
out there has ever had that same issue, and if there's maybe
some kind of override preventing me from making those changes.
It's extremely frustrating, as it used to work in the past.
Many thanks!
 
Replies continue below

Recommended for you

Per drafting standards all characters in a dimension are to be the same height. Just because they are small values is no reason to make them difficult to read.

Aside from that, WF5 is considered the worst version from PTC for drafting.
 
Really, I thought every subsequent release got worse?

----------------------------------------

The Help for this program was created in Windows Help format, which depends on a feature that isn't included in this version of Windows.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor