Hi all. I noticed that boiler stacks in my plant have an inverted canopy design. But I have also seen boilers in other plants have the 'normal' canopy design. What is the basis of designing the canopy to be inverted? My canopies now experience corrosion which I highly suspect because of water accumulation due to the inverted design. If i were to change the design to 'normal' canopy, will there be any significant impact on the flue gas release to atmosphere? Appreciate your opinion, thanks!
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Canopy Stack Design for Boilers
- Thread starter ashaari
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question