plaidgadjo
Mechanical
Hello all,
I'm working on an injection mold design in Creo 3.0 and can't seem to define a runner. I select "Runner" under the Mold & Cast menu and the dialog box opens, but when I click on "round trapezoid" for shape - no dialog opens... I do however see a click flash in the upper left corner of the screen that says "Menu Manager". I've tried a simple round runner and I am able to put in the diameter, but after I sketch the profile it never shows (not even in a preview). Any ideas?
Thank you in advance?
I'm working on an injection mold design in Creo 3.0 and can't seem to define a runner. I select "Runner" under the Mold & Cast menu and the dialog box opens, but when I click on "round trapezoid" for shape - no dialog opens... I do however see a click flash in the upper left corner of the screen that says "Menu Manager". I've tried a simple round runner and I am able to put in the diameter, but after I sketch the profile it never shows (not even in a preview). Any ideas?
Thank you in advance?