Can't delete assembly cut

[ALexBohm]

I have an assembly where I used assembly cuts to perform a match drill. On of the lower level parts was modified and now I can not delete or edit the cut. I get this error. I am using NX6.

"Failed to load part when trying to load part on demand"


Alex

 

[JohnRBaker]

Using NX 6.0.5.3 and performing a similar operation, 'drilling' a hole thru a shaft, at the Assembly level, for a pin to lock a cross-drilled nut, I had no problems deleting the Assembly Cut feature. I did this both after retrieving the assembly with and without partial loading enabled.

To help with issue we will need to see the at least the assembly with the minimum number of parts envolved with the Assembly Cut feature.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.