Can't Open ACIS File

[rollupswx]

Can you get the attached ACIS file created in SWx 2009 to open?

 

[JMirisola]

I did, using SW2010. I've attached an iges and SW file.
Hope this helps.

Jeff Mirisola, CSWP
Design Manager/Senior Designer
M9 Defense
My Blog

 

[CorBlimeyLimey]

Worked fine for me also. SW2010-SP4.0

Parasolid attached

 

[macduff]

Worked fine for me also.

Colin Fitzpatrick (aka Macduff)
Mechanical Designer
Solidworks 2010 SP 3.1
Dell 490 XP Pro SP 2
Xeon CPU 3.00 GHz 3.00 GB of RAM
nVida Quadro FX 3450 512 MB
3D Connexion-SpaceExplorer

 

[rollupswx]

Thanks guys. Did you run any quality checks?

Your files would open for me in a couple of other CAD programs but didn't pass quality checks. There are several poorly trimmed slivers (see attached). Apparently the original SWx operator didn't know what he was doing.

It wouldn't open for me in SWx 2009.

 

[CorBlimeyLimey]

The main casing has errors, but that's not necessarily the original CAD operators fault. It could have occurred during the conversion to SAT or importing into SW.

Are you able to obtain the original SW2009 file, or a parasolid from it?