Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cant select elements or nodes in FE Modeller

Status
Not open for further replies.
DrBwts

DrBwts

Mechanical
Nov 4, 2012
297
0
0
GB
ANSYS 17.1

I have imported an Abaqus beam mesh via the FE Modeller component but I cant select any of the nodes or elements in the graphics window.

FEM_ANSYS_Selction_issue_ssntgw.png
 
Status
Not open for further replies.

Similar threads

Tegguy
  • Locked
  • Question
ANSYS: Beam Elements vs Joint Stiffness?
Replies
11
Views
53
Tegguy
Tegguy
andradesilva
  • Locked
  • Question
modal analysis in ANSYS Mechanical APDL 2020 R2: How to see graphical results without mesh/elements
Replies
1
Views
23
NRP99
NRP99
andradesilva
  • Locked
  • Question
how to select a cross-section for a line built in Design Modeler in ANSYS workbench 2023 R1
Replies
0
Views
6
andradesilva
andradesilva
vickyiamlucky
  • Locked
  • Question
Ansys Symmetry model to full model cut boundary dispacemnt or force bc
Replies
0
Views
18
vickyiamlucky
vickyiamlucky
pnomura
  • Locked
  • Question
Drop Test in Transient Structural
Replies
1
Views
24
jamesdean2
jamesdean2
Back
Top