Hi there, does anyone have any good proposal for the carbon fiber threaded inserts. I found the ones on the link below, but they are hard do get in my country.
Thnaks,
Uroš
Thnaks,
Uroš
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Carbon fiber threaded inserts
- Thread starter Bozo_Sam
- Start date
The link you post does not match your question.
Do you mean this?
Might I politely suggest to all OTHER MEMBERS of Eng-Tips to refrain from posting until AFTER the OP has confirmed the actual correct part they are asking about? (Bozo_Sam, don't be offended by that comment - I have witnessed the effect of various members guessing their way to the wrong answer rather than just wait for the right question first. But, please check your links carefully before posting. I might have given you a specific answer already, if only you had done so, instead of this request for clarification.)
Do you mean this?
Might I politely suggest to all OTHER MEMBERS of Eng-Tips to refrain from posting until AFTER the OP has confirmed the actual correct part they are asking about? (Bozo_Sam, don't be offended by that comment - I have witnessed the effect of various members guessing their way to the wrong answer rather than just wait for the right question first. But, please check your links carefully before posting. I might have given you a specific answer already, if only you had done so, instead of this request for clarification.)
- Status
Similar threads
- Locked
- Question
- Locked
- Question