Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Casting Standards?

Status
Not open for further replies.
Enginerd9

Enginerd9

Mechanical
Jan 11, 2008
149
Does anyone know of a good reference for determining the appropriate standard to use when creating drawings? I'm looking for what standard to call for when interpreting my drawing for a cast part.

Thanks!
 
Replies continue below

Recommended for you

Sort by date Sort by votes
ASME Y14.5M-1994 is envoked by the casting spec ASME Y14.8M-1996 so you may still need that too.

KENAT, probably the least qualified checker you'll ever meet...
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Jugaado Engineer
  • Locked
  • Question
Shaft service Life according to Standards 1
Replies
4
Views
193
geesaman.d
geesaman.d
JENGA4
  • Locked
  • Question
Question on Amount of Flexibility with Standards
Replies
5
Views
115
JENGA4
JENGA4
gfthelen
  • Locked
  • Question
Thread Pitch Standards
Replies
2
Views
81
MGZmechanical
MGZmechanical
pperlich
  • Locked
  • Question
Acceptable Editions of Referenced Standards (VIII-1 Table U-3) 1
Replies
2
Views
76
pperlich
pperlich
KTEvans
  • Locked
  • Question
Hydraulic PRV safety standards ; US
Replies
0
Views
51
KTEvans
KTEvans

Part and Inventory Search

Sponsor

Back
Top Bottom