Catia build and hot fix in file

[thecadman3]

I am doing a small foreigner job using Catia V5. As part of the deliverables it says the models to be returned as Catia V5 r18 build 4 and hot fix 64.

I am able to do this on using on a spare works licence V5 r18 - but the build and hot fix is different.

Can anybody see this as an issue...I didn't think this info is recorded in the file is it?

 

[thecadman3]

sorry..not the build no but the service pack is different

 

[DBezaire]

It is and will only be an issue if they try and migrate your data back into their PDM. At that point they might/will refuse the data. It will not be an issue if you are not sending data back. If you open a part in wordpad you can see the version info. R18 SP8 HF0

CNEXTINFOS-UpdateVersion-StreamBlock-SafeEarlyBlock-StrongEarly&V5R18SP8HF0 built on 02-06-2009


Regards,
Derek

 

[thecadman3]

thanks..but it turns out I wont be doing this now anyway.