Hi,
I have created (for training purpose) the assembly attached to this message.
I want to create an electrical branch between the two components (Support001.1 and Support001-COPY.1).
The first one has electrical properties and accept to be the one of the ends.
The other one (a copy of the first part, used here for training purpose only) can not be selected for creating the other end of the branch.
It should be electrified, but I do not know how to do that (I tried to add Publications, but I couldn't get good results).
Could somebody give me a helping hand in this matter?
This thread is also visible in Dassault Catia Products
Please, open this link:
CAD 2015
I have created (for training purpose) the assembly attached to this message.
I want to create an electrical branch between the two components (Support001.1 and Support001-COPY.1).
The first one has electrical properties and accept to be the one of the ends.
The other one (a copy of the first part, used here for training purpose only) can not be selected for creating the other end of the branch.
It should be electrified, but I do not know how to do that (I tried to add Publications, but I couldn't get good results).
Could somebody give me a helping hand in this matter?
This thread is also visible in Dassault Catia Products
Please, open this link:
CAD 2015
