Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

CATIA Modeling and Drafting standards

Thread starter SteveKerns
Start date Feb 11, 2002

Status: Not open for further replies.

Feb 11, 2002

SteveKerns

New member

I am looking for CATIA V5 standards:
-How to model parts to get the most out of parametrics.
-Use of layers.
-Start-up models.
-Assembly models.
Also, are there ways of doing things that make things easier when using a PDM system?

Sorry for the cross-post. I was directed here from Aero to get more responses.