Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
catia v4
- Thread starter jk123
- Start date
jk123 --
use the control key and the alt key and
w for diameter
q for centerline sytmbol
r for omega
e for degree symbol
t for less than or equal
y for greater than or equal
u for plus minus
i for meu
o for the dot (multiplication)
a for down arrow
s for the spuare u shape
d for the arrow down with a line over it
and f for what looks like a sigma shape.
that is the best for v4.
use the control key and the alt key and
w for diameter
q for centerline sytmbol
r for omega
e for degree symbol
t for less than or equal
y for greater than or equal
u for plus minus
i for meu
o for the dot (multiplication)
a for down arrow
s for the spuare u shape
d for the arrow down with a line over it
and f for what looks like a sigma shape.
that is the best for v4.
- Status
