-
1
- #1
Hello All,
When creating a "Hole Dimension Table", is there any way to have catia recognise normal from threaded holes and fill in the table accordingly? I am having to edit the table afterwards to show the proper hole types. This has proven to cause some problems as somtimes we make mistakes or miss out on the tread and then it's only a pilot hole sitting there. Maybe there are some macro's out there too?
Thanks, Gary.
When creating a "Hole Dimension Table", is there any way to have catia recognise normal from threaded holes and fill in the table accordingly? I am having to edit the table afterwards to show the proper hole types. This has proven to cause some problems as somtimes we make mistakes or miss out on the tread and then it's only a pilot hole sitting there. Maybe there are some macro's out there too?
Thanks, Gary.
