Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

CATIA V5 Knowledge Pattern Creating New Part Bodies

Thread starter victorliu7672
Start date Jul 10, 2012

Status: Not open for further replies.

Jul 10, 2012

victorliu7672

New member

Hi,
I'm trying to generate multiple fittings using a UDF instantiated using a knowledge pattern. But I'm trying to put each of the UDF in a separate part body. I was wondering how to create a new part body using the knowledge pattern then set the part body as the destination of the UDF instantiation. The number of bodies needed is not constant so the bodies must be created in the knowledge pattern.

Thanks.