CATIA vbscript : drawing a view according to a choosen plane

[jissididi]

Hi there ,

Just wanted to know if there was a way to automate the creation of a drawing view choosing the plane and not just playing with the parameters of the
drawingViewGenerativeBehavior1.DefineFrontView 0000,0000,0000,0000,0000,0000
...
because i tried to find the logic used to choose the values of the 6 parameters and i just couldnt figure out....
it is actually not using nor degrees nor radians.

So if you have an idea to test or the solution please let me know !!!

Thanks

Jissididi Mechanical engineer

 

[itsmyjob]

DefineFrontView parameters are clearly explained in online doc...

Please check doc and tell us what you don't understand.

Eric N.
indocti discant et ament meminisse periti ​

 

[jissididi]

ok thanks !

I had not seen that page...