I'm an inexperienced user of Catia v5. I'm looking for the procedure of exporting a .dxf file from an .igs flat pattern. I know there is a way to convert a 3d model into a 2d flat pattern but I dont have the knowledge or time to figure it out. Any help would be greatly appreciated
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
catiav5 .igs to .dxf
- Thread starter sam413
- Start date
Similar threads
- Locked
- Question
- Locked
- Question