Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

CATProcess won't show updates to CATProduct

Status
Not open for further replies.
fighterpilot

fighterpilot

Military
Nov 5, 2004
381
I have a CATProcess (DELMIA) simulation that will not show updates made to the CATProduct file it references. One part in particular shows up in red for some reason.

Any suggestions?

--
Fighter Pilot
Manufacturing Engineer
 
Status
Not open for further replies.

Similar threads

Hix066
  • Locked
  • Question
Modify the default CATPart / CATProduct?
Replies
1
Views
69
Little Cthulhu
Little Cthulhu
Caio74
  • Locked
  • Question
macro numerazione visiva catproduct e relativi catpart
Replies
0
Views
48
Caio74
Caio74
CarlosR2022
  • Question
Is it possible to show and hide "Points" & "Wires" similar to the options se
Replies
1
Views
201
LWolf
LWolf
NikoJzzz
  • Locked
  • Question
How to show dual value of max and min total values
Replies
2
Views
65
NikoJzzz
NikoJzzz
Korey_with_a_K
  • Locked
  • Question
CATIA V6 / 3DX BOM generation from CATProduct
Replies
5
Views
140
Azzazil
Azzazil

Part and Inventory Search

Sponsor

Back
Top Bottom