Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Center distance of bottom rolls in pyramid type plate bending m/c

Thread starter CHARLESCOSTA
Start date Aug 29, 2007

Status: Not open for further replies.

Aug 29, 2007

CHARLESCOSTA

Structural

For the design of pyramid type plate bending m/c,what should be the optimum center distance between bottom rolls.Dias of top and botttom roll have been calculated based on the plate thickness and the load required to bend it to required radius .Any suggested references?