Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Center of Mass Point Generation

Status
Not open for further replies.
TheMan51

TheMan51

Automotive
Feb 8, 2007
109
0
0
US
I have an assembly that has 5 parts. Using tools/mass properties, I calculated the X,Y,Z center of mass. Is there a way to place a point or coordinate system at this location?
Thanks in advance.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
and or see the FAQ
faq559-356

-Dustin
Professional Engineer
Certified SolidWorks Professional
Certified COSMOSWorks Designer Specialist
Certified SolidWorks Advanced Sheet Metal Specialist
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Platypusimon
  • Locked
  • Question
calculating the mass & volume of section of a part/assembly model in solidworks
Replies
10
Views
36
jassco
jassco
oharag11
  • Locked
  • Question
How do I add a generic mass to a Solidworks part?
Replies
5
Views
27
oharag11
oharag11
Platypusimon
  • Locked
  • Question
MCI of different sections of an assembly
Replies
4
Views
15
jassco
jassco
CAD2015
  • Locked
  • Question
Rotate a view in the direction of a line.................. 3
Replies
17
Views
18
jassco
jassco
Channo
  • Locked
  • Question
Need help with increasing poly count of 3D model
Replies
9
Views
19
3DDave
3DDave
Back
Top