Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Century Electric Co. Motor Information

Status
Not open for further replies.

bpitreau

Mechanical
May 19, 2006
3
Does anyone know where I can find information on an old Century Motor? In particular I'm trying to find out a proper replacement and need to find out whether its single or double winding.

On the nameplate, there is a line that reads:

3S.2W.VAR.TORQ.

Does this give any insight into what I need.

I appreciate any help.

Thanks.

Brian
 
Replies continue below

Recommended for you

If it has a nameplate, could you post all the "nameplate data"?. Additional information like the numbert of terminal wires and the tag number on each lead, and the operating speeds will help too.
 
I don't have information on the leads, but here is the nameplate:

Century
Model: SCM-254-NA3-101N
H.P.: 3-1.3-.75
Ph: 3
RPM: 1760-1175-875
CY: 60
Volts: 208
AMPS: 8.4-5.1-3.3
Time Rating: Cont. Open
Temp Rise: 40 deg. C
Unnamed item: 3S.2W.Var.Torq
Serial No. 5AS20994

This is a 3 speed motor, as you can tell, but we're replacing with a 2-speed since its difficult to find a 3-speed replacement, and currently they're only controlling it as a 2-speed.

Again, any help would be appreciated.

 
Century was bought by Magentek, who was bought by A.O. Smith. Contact A.O. Smith now, they should be able to help.


Eng-Tips: Help for your job, not for your homework Read faq731-376 [pirate]
 
Hi bpitreau:

Now is more clear. 3S.2W.VAR.TORQ means 3 speeds, 2 windings, Variable Torque.

For two speeds, You could buy a similar motor 3 phase, 60 HZ, 208 Volts and adapt the shaft and mounting.

for 3HP-1760 rpm and 0.75HP-875 rpm you can get a single winding variable torque motor.

If you need the 1.3HP-1175 rpm and any other of the two remaining, it has to be a two winding motor.

Single winding motors are possible only with poles ratio 1/2 (2/4, 4/8, 6/12, etc)
 
Excellent,

That sheds a lot of light on this situation as well 1 vs. 2 winding motors in general. I appreciate your input on this.

This was the first time I had posted here, and I am very happy with the results.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor