Franklin M.
Aerospace
- Jan 20, 2018
- 59
I miss the chaining feature in older versions, (I use NX6 frequently). I'm back on NX12 and I'm again finding the loss of chaining to be bothersome. I've tried the options in the selection menu that appears when I select curves but it gives me the same result as selecting a face (cannot control the start/stop). I'm probably missing something though I have done several searches both here and on the internet in general, both have been fruitless. Anyone care to point me in the right direction?
Franklin
UG 10,13 & 18
NX 1,2,4,6,11 & 12
NCL502 (yep I love Sequential Mill)
Franklin
UG 10,13 & 18
NX 1,2,4,6,11 & 12
NCL502 (yep I love Sequential Mill)