Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Champer Dimension Tolerance 1

Status
Not open for further replies.

CAD2015

Automotive
Joined
Jan 21, 2006
Messages
2,079
Location
US
Hi,

I wanted to add tolerance for both dimension of the champer.
But I couldn't add tolerance for the second dimension.
So, I created a text and ready to place it at the arrow location:


image_a5nw8q.png


This detailed is shown very accurate in the Catia Drawing file I attached to this thread.
My question is: Is it possible to add tolerances for both champer dimension (maybe in Properties), other than substituting with text?

Thank you!

CAD 2015
 
I'm not quite sure about the format of what you are showing there or what you are trying to do. Never seen a chamfer called out like that. In any case, what you are looking for is RMB > Properties > Tolerance. There are a bunch of options there. There is also a drop down menu in the toolbars that can do the same things.

Don't forget that you don't need to use the chamfer dimension. You could provide more control over what you are doing by using two separate linear dimensions.

Regards,
Jason C. Wells
 
Jason

Thanks for your message.
I work under engineering supervision.
The engineer gave me a marked-up project and asked to include tolerances for the chamfer.

CAD 2015
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top