Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Changing Chart Options

Status
Not open for further replies.
sloth4z

sloth4z

Mechanical
Aug 12, 2003
132
I am looking at a Design Check plot. When I go into Chart Options to change the scale to a defined scale, the change is only temporary. After I change plots and reopen the original plot, the changes are removed. How do I get the changes to "set in".

I am using SW2006 SP4.1, and CosmosWorks 2006 SP4.0.
 
Status
Not open for further replies.

Similar threads

robbo13
  • Locked
  • Question
Changing temporary directories in COSMOS
Replies
3
Views
24
kellnerp
kellnerp
Robbo1971
  • Locked
  • Question
COSMOSWorks 2009 Chart Options
Replies
4
Views
40
kellnerp
kellnerp
Dundorf
  • Locked
  • Question
How does SW Sim/Comos respond to changing contact areas?
Replies
1
Views
20
kellnerp
kellnerp
sloth4z
  • Locked
  • Question
Chart Options
Replies
0
Views
16
sloth4z
sloth4z
sloth4z
  • Locked
  • Question
Design Scenario not changing values
Replies
1
Views
35
sloth4z
sloth4z

Part and Inventory Search

Sponsor

Back
Top Bottom