Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Changing Draftsight Print Margins

Thread starter MysteriousDrX
Start date Sep 14, 2011

Status: Not open for further replies.

Sep 14, 2011

MysteriousDrX

Aerospace

Is it possible to change the size of the print margins in DraftSight?

I need them the be an even 0mm or 5mm on all four sides, however I can find no way to physically changes them.

Or at least if I could find out what the existing margins are then I could adjust my border template accordingly.

Surely it must be possible to do one of these things!?