McDermott1711
Mechanical
- Nov 17, 2010
- 318
thread378-267056
I was reading this thread and with regard to OP question:
I think, at that time maybe for pipes larger than 24" the available vendor of fiberglass pipe did not have an oven large enough to cure larger-than-24"-pipes. Therefore, the choice between not-cured GRVE and CS with internal coating of glass-flake epoxy resulted in second option.
What's your opinion?
Nothing is more fairly distributed than common sense: no one thinks he needs more of it than he already has. Rene Descartes
I was reading this thread and with regard to OP question:
MrMechanik said:In your opinion why the designer of PMS decided to change from GRE to CS (glass flake lined) for large sizes?
I think, at that time maybe for pipes larger than 24" the available vendor of fiberglass pipe did not have an oven large enough to cure larger-than-24"-pipes. Therefore, the choice between not-cured GRVE and CS with internal coating of glass-flake epoxy resulted in second option.
What's your opinion?
Nothing is more fairly distributed than common sense: no one thinks he needs more of it than he already has. Rene Descartes