Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Changing views of a model/assembly

Status
Not open for further replies.

jonmwilson

Mechanical
Feb 23, 2010
49
I am new to Inventor 2012 and am having trouble changing the "Front" view of my assembly. currently in my part the bottom view is what is shown when I click on "Front" view in my cube. Is there a way to correct this after the assembly is already complete? Thanks.
 
Replies continue below

Recommended for you

In Inventor - right click everything.

Right click the View Cube and select Set Current View as Front.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor